Champions League

Disassembly and Champions Leagueinstallation of engine steps (disassembly of engine and installation operation guide) When repairing a car, disassembly and installation of the engine is a very important task. It may take a lot of time and effort to remove the engine, but if you follow the correct steps, the operation will become easier and faster. This article will introduce the steps to disassemble the engine and the installation operation guide. I. Disassembly of the engine Step 1. Prepare tools and equipment. Before starting to disassemble the engine, you need to prepare the required tools and equipment, such as wrenches, jacks, jacks, and power tools.In addition, before removing the engine, it is necessary to ensure that the vehicle is located on a flat ground and there is enough space for operation. Two. Cleaning the engine compartment Before removing the engine, the engine compartment needs to be thoroughly cleaned to avoid polluting the engine during the disassembly process. Low-pressure water gun or car detergent can be used for cleaning. 3. To remove the battery, the positive and negative poles of the vehicle battery need to be removed to avoid a short circuit during the disassembly process. Four. Emptying the coolant and oil Before disassembling the engine, the coolant and oil need to be emptied to avoid splashing during the disassembly process. 5. To remove the intake pipe and exhaust pipe, you need to remove the intake pipe and the exhaust pipe. 6. To remove the drive device, you need to remove the drive device connected to the engine, such as the transmission system or clutch. 7. Remove the part connecting the engine. Remove the part connecting the engine, such as radiator, water pump, generator, etc.Eight. The fixation of the chassis needs to be determined on one side of the frame of the chassis, and the engine should be raised to a height with a support frame for easy disassembly. Nine. Remove the engine. After checking and confirming that there is no other fixation of the engine, you need to use a jack and a support frame to lift the engine gradually until the engine can be removed and moved out of the vehicle. II. Installation Operation Guide 1. Prepare the tools and equipment required for installation. Before installing the engine, you need to prepare the tools and equipment needed during the installation process, such as support frames, jacks, wrenches, pneumatic tools, etc. Two. Confirm the installation position. Before installation, you need to confirm the installation position, put the engine on the support frame, and adjust the height. 3. The installation connection part will install the part that has been disassembled, and confirm the tightness of the connection.Four. Confirm the electrical wiring. Confirm that the battery and electrical appliances of the engine have been wired correctly. 5. Add lubricating oil and coolant. A sufficient amount of oil and coolant needs to be added before installing the engine to avoid damage caused by lack of oil or liquid during the working process. 6. Check the work and test. After confirming that all the work is completed, the engine needs to be started for testing. Confirm that the engine is running normally, check whether the engine is stable, and make necessary adjustments. 7. Check the operation order. After completing the installation of the engine, it is necessary to carefully check whether all operations are completed in the correct order. Confirm the tightness of all fasteners and connecting parts and make necessary adjustments. The above are the steps for disassembling and installing the engine and the installation operation guide. If you need to disassemble and install the engine, you should follow the above steps. If you are not familiar with the above operations, it is recommended that you find a professional maintenance technician to operate.

Contact Us
Phone：020-83484673