Bingo Plus

Engine water tank radiator (original replacement guide for engine cooler) In the process of driving,Bingo Plus the engine will constantly generate heat during operation. If there is no good heat dissipation mechanism, it will cause the engine to overheat, making The engine is damaged or the engine fails. The engine water tank radiator is an important part of the engine cooling system. It takes away the heat generated by the engine through water circulation to ensure that the engine is at a suitable working temperature and avoid overheating. However, the engine tank radiator needs to be checked and maintained frequently. When a problem is found, the engine tank radiator needs to be replaced. The following is a replacement guide for the engine tank radiator, hoping to help you maintain your car more effectively.1. Prepare tools and parts. Before replacing the engine tank radiator, you need to prepare the corresponding tools and parts: 1) New radiator: Choose a suitable new radiator according to the requirements of the model. 2) Wrench: 8mm and 10mm wrenches are usually required. 3) Screwdriver: It is needed to remove the relevant connection screws. 4) Antifreeze: It is used to discharge coolant and add new coolant before replacing the radiator. 5) Funnel: used to add new coolant. Two. Remove the radiator a. Turn off the engine first to make sure that the engine and radiator have cooled down. If necessary, you can dump the old coolant first. B. Remove the pipe between the water tank and the radiator with a wrench. Note that you may also need to remove the water tank accessories, such as the fan and the upper water tank bracket. C. Disassemble the radiator itself. Usually, you need to remove the bracket of the radiator first, and then remove the radiator from the bracket.3. Install a new radiator a. Install the new radiator on the bracket and fix the bracket to the car with the new radiator. B. Connect the water pipe to the new radiator. Use a wrench to tighten the connection screw to ensure that it is well sealed. C. If necessary, reinstall any required water tank accessories, such as fans and upper water tank brackets. Four. Add coolant a. Open the engine cover and find the coolant tank. B. Add an appropriate amount of new antifreeze to the coolant tank with a funnel. Note that it should not exceed the liquid level mark. C. Start the vehicle, let the engine run, and check for any water leakage or leakage. If there is, stop and check immediately. The above are the basic steps to replace the engine water tank radiator. Please remember that the entire cooling system should be checked before replacing the water tank radiator, includingThe quality and liquid level of the coolant, the working status of the pump, and other cooling system components ensure that the vehicle is in normal operation. It should be noted that before replacing the engine radiator, if you are not familiar with vehicle maintenance and do not have relevant experience or tools, it is recommended to seek professional technical support. If you have any other questions, you can also consult the relevant professional and technical personnel.

Contact Us
Phone：020-83484673